Konfiguration/Eigenes WLAN
Warnung! Nur für Fortgeschrittene!
Mit folgender Konfiguration kann man einen TP-Link TP-WL1043ND durch zwei VLANs über Ethernet-Kabel sowohl mit FFKI-Mesh-Netz versorgen als auch als Access-Point für ein eigenes WLAN benutzen.
- /etc/config/network
config interface 'loopback'
option ifname 'lo'
option proto 'static'
option ipaddr '127.0.0.1'
option netmask '255.0.0.0'
config switch
option name 'rtl8366rb'
option reset '1'
option enable_vlan '1'
option enable_vlan4k '1'
config switch_vlan
option device 'rtl8366rb'
option vlan '1'
option ports '1 2 3 4 5t'
config switch_vlan
option device 'rtl8366rb'
option vlan '2'
option ports '0t 5t'
config switch_vlan
option device 'rtl8366rb'
option vlan '3'
option ports '0t 5t'
config interface 'wan'
option ifname 'eth0.2'
option proto 'dhcp'
option type 'bridge'
option accept_ra '0'
option auto '1'
option macaddr '<nimmdeineeigene-1>'
config interface 'freifunk'
option ifname 'eth0.1 bat0'
option type 'bridge'
option proto 'none'
option auto '1'
option accept_ra '1'
option macaddr '<nimmdeineeigene-2>'
config interface 'mesh'
option proto 'batadv'
option mesh 'bat0'
option mtu '1528'
config interface 'mesh_lan'
option ifname 'eth0.3'
option proto 'batadv'
option mesh 'bat0'
- /etc/config/wireless
config wifi-device 'radio0'
option type 'mac80211'
option channel '11'
option macaddr '<nimmdeineeigene-2>'
option hwmode '11ng'
list ht_capab 'SHORT-GI-40'
list ht_capab 'DSSS_CCK-40'
option htmode 'HT40-'
option country 'DE'
config wifi-iface 'wifi_freifunk'
option device 'radio0'
option network 'freifunk'
option mode 'ap'
option ssid 'http://kiel.freifunk.net/'
config wifi-iface 'wifi_mesh'
option device 'radio0'
option network 'mesh'
option mode 'adhoc'
option ssid '02:ca:ff:ee:ba:be'
option bssid '02:ca:ff:ee:ba:be'
option mcast_rate '12000'
config wifi-iface 'wifi_ap'
option device 'radio0'
option network 'wan'
option mode 'ap'
option ssid 'meineEigeneKomischeSSID'
option encryption 'psk2'
option key 'WPA2-PSK-Key-fuer-meineEigeneKomischeSSID'